Sánchez-Mesa, Rosa J.Cortés-Hernández, Diego M.Gálvez-Sahagún, BenjamínRayas-Sánchez, José E.Brito-Brito, Zabdiel2019-08-302019-08-302018-12R.J. Sánchez-Mesa, D.M. Cortés-Hernández, B. Gálvez-Sahagún, J.E. Rayas-Sánchez, and Z. Brito-Brito, “A novel high-performance length matching element for high-speed interconnect differential channels,” in IEEE MTT-S Latin America Microwave Conf. (LAMC-2018), Arequipa, Peru, Dec. 2018, pp. 1-3. DOI: 10.1109/LAMC.2018.8699027978-1-5386-7334-8http://hdl.handle.net/11117/6014Length matching elements (LME) are used for intra-pair length matching and inter-pair skew reduction to get high data rates in high-speed differential channels. Although these structures are widely used in printed circuit boards (PCB), the effectiveness of the structure depends on its geometry and dimensions, allowing different design alternatives. In this work, a novel LME for PCB designs is proposed. It is formed by three sub-structures, such that the insertion and impedance profile can be parametrically controlled by the geometry of the proposed LME without affecting the length matching. Mixed-mode parameters, extracted from simulation data, shows that the proposed LME presents lower insertion loss and less electromagnetic interference (EMI), than trapezoidal LME. In addition, time domain reflected analysis (TDR) shows better impedance profile for the proposed LME than for the trapezoidal shape. Both frequency- and time-domain results indicate that the proposed LME can be a good alternative for length matching compensation in high-speed channels.engADSDifferential InterconnectsFull-wave EM SimulationHigh-speedHFSSLength Matching ElementMode ConversionPCBS-parametersTDRinfo:eu-repo/semantics/article